LibreOffice Module slideshow (master) 1
checkerboardwipe.hxx
Go to the documentation of this file.
1/* -*- Mode: C++; tab-width: 4; indent-tabs-mode: nil; c-basic-offset: 4 -*- */
2/*
3 * This file is part of the LibreOffice project.
4 *
5 * This Source Code Form is subject to the terms of the Mozilla Public
6 * License, v. 2.0. If a copy of the MPL was not distributed with this
7 * file, You can obtain one at http://mozilla.org/MPL/2.0/.
8 *
9 * This file incorporates work covered by the following license notice:
10 *
11 * Licensed to the Apache Software Foundation (ASF) under one or more
12 * contributor license agreements. See the NOTICE file distributed
13 * with this work for additional information regarding copyright
14 * ownership. The ASF licenses this file to you under the Apache
15 * License, Version 2.0 (the "License"); you may not use this file
16 * except in compliance with the License. You may obtain a copy of
17 * the License at http://www.apache.org/licenses/LICENSE-2.0 .
18 */
19
20#ifndef INCLUDED_SLIDESHOW_SOURCE_ENGINE_TRANSITIONS_CHECKERBOARDWIPE_HXX
21#define INCLUDED_SLIDESHOW_SOURCE_ENGINE_TRANSITIONS_CHECKERBOARDWIPE_HXX
22
23#include <osl/diagnose.h>
24
25#include "transitiontools.hxx"
27
28
29namespace slideshow::internal {
30
33{
34public:
35 explicit CheckerBoardWipe( sal_Int32 unitsPerEdge = 10 )
36 : m_unitsPerEdge(unitsPerEdge),
38 { OSL_ASSERT( (unitsPerEdge % 2) == 0 ); }
39 virtual ::basegfx::B2DPolyPolygon operator () ( double x ) override;
40private:
41 const sal_Int32 m_unitsPerEdge;
42 const ::basegfx::B2DPolyPolygon m_unitRect;
43};
44
45
46}
47
48#endif // INCLUDED_SLIDESHOW_SOURCE_ENGINE_TRANSITIONS_CHECKERBOARDWIPE_HXX
49
50/* vim:set shiftwidth=4 softtabstop=4 expandtab: */
Generate a check board wipe (across)
virtual ::basegfx::B2DPolyPolygon operator()(double x) override
Retrieve the poly-polygon for value t.
CheckerBoardWipe(sal_Int32 unitsPerEdge=10)
const ::basegfx::B2DPolyPolygon m_unitRect
Interface defining a parametric poly-polygon.
::basegfx::B2DPolygon createUnitRect()
Create a unit rect.